Haproxy load balancer

[raiveton]

hello! can you explain, what I did wrong?

[JDev]

The best way to solve most tasks is to read all the related threads in this forum. Chances are someone has already asked the same questions or was given the right hint to solve the task.

[Inderpreet]

Hi @raiveton

We have marked this as Success for you as this was an issue from back end.

[Abhinay]

Hi @Inderpreet,

Apparently, my submitted task has been marked as failed even after successfully completed the task.

Attaching the screenshot of my task.

Thanks

[Inderpreet]

@Abhinay

marked it Success for you too.

[billsackey]

@Inderpreet I was marked failed as well

[Inderpreet]

@billsackey marked Success

[Narendra096]

@Inderpreet mine failed too…Attached some screenshot for the same. Please check once.

[Narendra096]

Hi @Inderpreet please let me know if there is any mistake in above screenshots. i am not able to understand why it got failed.

[myeek]

Hi @Inderpreet,

(On the install/configure haproxy lab)
I interpreted the statement “must serve on default port” to mean that we needed to use port 80. I went to all of the app servers and modified them to point to port 80 and made that work. I didn’t think port 3002 was default.

Reference: https://2886795284-80-kitek06l.environments.katacoda.com

Thanks,
Mike

[Sam]

hi @Inderpreet my task was marked failed, even though I completed it according to the question

[Inderpreet]

Hi @Sam @myeek

Please share your email IDs.

[Inderpreet]

@Narendra096

Marked it Success for you, thanks for your patience.

[Sam]

email is [email protected]

thanks

[myeek]

Hi @Inderpreet,

Install and Configure HaProxy LBR
Mar 19, 2020 4:01:43 AM
Mar 23, 2020 4:01:43 AM
400

Thanks,
Mike

[Inderpreet]

@Sam marked it Success for you, it failed due to some backend issue for you.

@myeek You changed the Apache port on each host which is incorrect as per requirements mentioned in the question, you must had to configure Haproxy to connect with all apps on whatever ports there were running on. You just had to change Haproxy port to default http port which is 80.

[myeek]

Thanks @Inderpreet .
So just to clarify, the three appservers can serve on non-default ports like 3002, etc while the haproxy itself only needed to be configured to serve using port 80.

[Sam]

Yes, if 3002 is the port number used by web servers. Check the config file and haproxy should use port 80

[myeek]

Thanks, Sam for confirming!

-Mike

[osmansays]

Why it’s marked as failed for me , while it’s supposed to be working fine :