About connection of labs

Terraform
#1

Hi all,

The laboratory connection is constantly disconnected. I can not work. Could you please fix it?

Thank you
Best Regards
Elif

#2

Hi @Elif-Basargil,

Sorry to hear that, you have been facing some issue on labs. Can you please provide us the link to the concerned labs?

Regards.

#3

Hi,

Thank you for your interest!

Especially the following lab has a big problem. It shows “## Ops, There is an error! Request failed with status code 500” on the screen after 7. questions. it does not accept the answer which you show then suddenly this error pops up.

Generally, Terraforms labs have problems. The connection is frequently disconnecting. every time I have to press ctrl + shift +~ and again I have to make things that I could not complete. for example, when I use vi editor it happens all of my doing is going.

Thank you
Best Regards
Elif

#4

Hi @Elif-Basargil,
Just tested all the labs without any issue, and it’s work fine, just be sure to do all instructions on each question. On Question.7 for example you need to run terraform init and terraform plan otherwise the response will not be accepted.

Capture d’écran du 2023-02-06 19-58-15
Capture d’écran du 2023-02-06 19-58-15731×161 16 KB

It’s better to use the VS Code editor provided on the labs and use the terminal to only run command

Regard

#5

Thank you for your answer. I am used to terminal generally. I suppose when I had a problem while using vi editor during theexit time as wq! . Anyway I tried VS Code editor. It is easier.

Best Regards
Elif

1 Like